Filling With Water; Indicator Light; Tools And Accessories - Bissell STEAM SHOT 39N7 Series User Manual

Operati s

Filling with Water

1. Push down on the safety cap while turning
counter-clockwise.
2. Fill measuring cup to the max fill line.
3. Slowly pour water into steamer.
NOTE: Do not add anything except cool
water or you will cause damage to the
heating element and void your warranty.
4. Replace the safety cap by pushing down
while turning clockwise.
If your tap water contains a high level of
mineral content (hard water) the use of distilled
or demineralised water is recommended.
Power Cord
Unwrap Power Cord before operating unit.

Indicator Light

The red Indicator Light will go on when the unit
is first plugged in. When the steamer is ready to
use, the light will turn off.
Steam Trigger
Push to release steam.
In order to refill the water tank after emptied,
the trigger must be engaged to release all the
steam/pressure that may be built up. Press the
trigger to release all the steam/pressure.

Tools and Accessories*

The Accessory Nozzle can be attached directly
to the steamer or the end of the extension hose.
The Accessory Nozzle and extension hose
attached in the same manner. Align the arrow on
the tool with the (I) mark on the Steam Shot™
and turn clockwise until the arrow aligns with the
(II) mark on the steamer.
A. Extension Hose
For cleaning hard to reach areas. Attach to unit
and use with the Accessory Nozzle attached.
B. Accessory Nozzle
Attach to unit or hose. Use alone or with a
tool attached
C. Detail Brush Tool (set of 3)
Attach to end of the Accessory Nozzle for
scrubbing stubborn soil. Color coded for
specific use.
d. Flat Scraping Tool
Attach to the end of Accessory Nozzle
for removing wallpaper, gum and extra
sticky messes.
e. Angle Concentrator Tool
Attach to end of the Accessory Nozzle to steam
clean hard-to-reach areas.
*Tools and accessories vary by model.
WARNING
Always unplug your Steam Shot™ before fi lling/refi lling.
Press trigger until steamer depressurises. Wait 5 minutes
before removing cap.
1. 2.
3. 4.
WARNING
Before disconnecting a tool from the steam cleaner, make
certain that steam is no longer coming from the nozzle.
Use an oven mitt to remove tools, or wait until they cool
before removing.
a. b.
c. d.
e.
www.BISSELL.ca
5