Removing Right Control Panel; Installing Left Control Panel - Dell EMC VxFlex Ready Node R840 Manual

Hardware FRU procedures

Removing right control panel

VxFlex Ready Node R840 Hardware Field Replacement Unit and Service Manual
160
Figure 75 Installing left control panel
Before you begin
Follow all safety guidelines.
Note
Ensure that you note the routing of the cables as you remove them from the system
board. To prevent the cables from being pinched or crimped, route the cables properly
when you replace them.
Procedure
1. Disconnect the VGA cable from the system board.
2. Open the cable latch, and disconnect the control panel cable from the system
board connector.
3. Using a Phillips #1 screwdriver, remove the screws that secure the control panel
and ribbon cable to the system.
4. Holding the control panel and ribbon cable, remove the control panel along with
the ribbon cable away from the system.