Removing The Processor From The Processor And Heat Sink Module; Removing The Processor And Heat Sink Module 2U - Dell EMC VxFlex Ready Node R840 Manual

Removing the processor from the processor and heat sink module

Figure 55 Removing the processor and heat sink module 2U
Before you begin
WARNING
The heat sink may be hot to touch for some time after the system has been
powered down. Allow the heat sink to cool before removing it.
Note
Only remove the processor from the processor and heat sink module if you are
replacing the processor or heat sink. This procedure is not required when replacing a
system board.
Procedure
1. Place the heat sink with the processor side facing up.
2. Insert a flat blade screwdriver into the release slot marked with a yellow label.
Twist (do not pry) the screwdriver to break the thermal paste seal.
3. Push the retaining clips on the processor bracket to unlock the bracket from
the heat sink.
Removing the processor from the processor and heat sink module
Hardware FRU procedures
129