Sony digital handycam DCR-TRV10 Operating Instructions Manual page 60

Inserting a scene from a VCR
(1) Set the POWER switch to VTR.
(2) On the VCR, locate just before the insert start point [a], then press X to set the VCR
(3) On your camcorder, locate the insert end point [c] by pressing m or M. Then
(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET MEMORY
(5) On your camcorder, locate the insert start point [b] by pressing m, then press
(6) First press X on the VCR, and after a few seconds press X on your camcorder to
4
To change the insert end point
Press ZERO SET MEMORY again after step 5 to erase the ZERO SET MEMORY
indicator and begin from step 3.
Note
The picture and sound recorded on the section between the insert start and end points
will be erased when you insert the new scene.
When the inserted picture is played back
The picture and sound may be distorted at the end of the inserted section. This is not a
malfunction.
To insert a scene without setting the insert end point
Skip step 3 and 4. Press x when you want to stop inserting.
60
to the playback pause mode.
press X to set it to the playback pause mode.
indicator flashes and the end point of the insert is stored in memory.
two z REC buttons at same time to set your camcorder to the recording pause
mode.
start inserting the new scene.
Inserting automatically stops near the zero point on the tape counter. Your
camcorder automatically returns to the stop mode.
ZERO SET
MEMORY
0:00:00
ZERO SET
MEMORY
5
REC