Table of Contents
Advertisement
Steps
1. Place the fan and heat-sink assembly on the system board.
2. Align the screw holes on the fan and heat-sink assembly to the screw holes on the system board.
3. In sequential order (1>2>3>4>5>6>), tighten the six captive screws (M2x4) that secure the fan and heat-sink assembly to the
system board.
4. Turn over the system-board assembly.
Next steps
1. Follow the procedure from step 6 to step 25 in
2. Install the
rear-I/O
cover.
3. Install the
wireless
card.
4. Install the
M.2 2230 solid-state drive
5. Install the
M.2 2230 solid-state drive
6. Install the
memory
module.
7. Install the
base
cover.
8. Follow the procedure in
Ethernet and audio board
Removing the ethernet and audio board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
memory
module.
Installing the system
or
M.2 2280 solid-state drive
or
M.2 2280 solid-state drive
After working inside your
Before working inside your
board.
in slot one, whichever applicable.
in slot two, whichever applicable.
computer.
computer.
59
Advertisement
Table of Contents
