Shindaiwa PowerBroom X7502235300 Owner's/Operator's Manual page 8

Assembly (continued)
Sweeper Assembly
1. Push one of the drum axles onto
either of the two gearcase output
shafts. If necessary, rotate the drum
axle until the clevis pin hole in the
axle aligns with the matching hole in
the gearcase output shaft.
CAUTION!
The two drum assemblies are
identical, but each drum must be
installed with its recessed end
facing toward the gearcase.
8
Drum
Assembly
2. Use a clevis pin and hitch pin to
secure the drum axle to the shaft.
3. Slide the recessed end of a sweeper
drum assembly over the installed
axle, and then push the drum down
the axle until the cotter pin hole in
the axle extends above the drum
surface.
4. Use a cotter pin to secure the drum
assembly on the axle (see inset).
The cotter pin is designed to fit
tightly against the outboard end of
the drum, so you may need to com-
press the drum face slightly during
installation. spead the ends of the
cotter pin to secure.
2 Secure the drum
axle to the shaft
Clevis
Pin
Drum
Axle
Cotter
Pin
Secure with a
cotter pin
4
Install the sweeper drum
assembly
Hitch
Pin
Install drum
1
axle onto
output shaft
3
5. Repeat Steps 1-4 to install the remain-
ing axle and drum assembly.
The PowerBroom tool should
now be completely assembled.