Sharp CD-G10000 Operation Manual page 35

Sequential recording from several discs:
1 Perform steps 1 - 5 in "Recording from a CD or MP3 disc" on page
34.
2 Within 5 seconds, press the /
To perform programmed recording:
1 Program discs and tracks (see pages 25, 29).
2 Press the button.
3 Press the / button.
To stop recording:
Press the button.
The disc and tape will stop.
Recording from the radio
1
Tune in to the desired station (see page 30).
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the button.
Recording will be paused.
4
Press the / button to start recording.
To interrupt recording:
Press the button.
To resume recording, press the /
To stop recording:
Press the button.
Note:
If you hear a whistling noise while recording an AM station, move
the AM loop antenna.
You can record from TAPE 1 to TAPE 2.
1
button.
2
3
4
5
To stop dubbing:
Press the
TAPE 1 and TAPE 2 will simultaneously stop.
button.
1 Load the tape to be erased into the TAPE 2 cassette compart-
2 Press the TAPE (1
3 Press the
4 Press the
Note:
Make sure that the TAPE 1 is not in use.
Dubbing from tape to tape
Press the ON/STAND-BY button to turn the power on.
Load a prerecorded cassette
into the TAPE 1 cassette com-
partment. Insert a blank tape
into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape is the same length as
the master tape.
Press the TAPE (1 2) button until "TAPE 1" appears on
the display.
Press the button.
Recording will be paused.
Press the / button to start dubbing.
button.
Erasing recorded tapes
ment with the side to be erased facing toward you.
2) button until "TAPE 2" appears on the dis-
play.
button.
/ button to start erasing.
CD-G10000
CP-G10000S
TAPE 1 TAPE 2
35