Part 8 Reference; Cleaning The Printer Head And Roller; To Clean The Printer Head And Roller; Initial Power On Settings - Casio KL-100 User Manual

Part 8 Reference
This section contains information about the Label Printer that you can use as
reference when you need it.

Cleaning the Printer Head and Roller

A dirty printer head and roller can result in poor printing quality. If you have
problems with print quality, use the following procedure to clean the printer head
and roller.

To clean the printer head and roller

1. Make sure the Label Printer is turned off.
2. Turn over the Label Printer, and open the back cover while pressing down
on its lock.
3. Remove the tape cartridge.
4. Use a cotton swab dipped in alcohol to clean
the printer head and roller as shown in the illus-
tration.
5. Replace the tape cartridge and close the back cover.
E-18

Initial Power On Settings

The following are the initial settings of the Label Printer whenever you turn it
power on.

Initializing the Label Printer

If you experience serious malfunction of the Label Printer or if operation fails
completely, try performing the following operation to initialize the printer.
Important!
• Initializing the Label Printer deletes all memory contents. Make sure you have
Print head
a back-up copy of text stored in memory if you need it.

To initialize the Label Printer

1. Turn power off.
2. While holding down the PRINT and ESC keys,
3. Keeping PRINT and ESC held down, release
• This prompt confirms whether or not you want to
initialize the Label Printer.
4. Press SET to initialize the Label Printer or ESC to abort the reset operation.
Roller
• The following table shows the initial settings.
Item
SIZE
EFFECT
STYLE
MIRROR
M-FEED
6mm
press ON to turn power on.
the ON key only.
Power On
JUST (2×2)
CANCEL
NORMAL
OFF
NO
OFF
INT?