Sharp AR-M160 Operation Manual page 48

USER SETTINGS
Program
Program name
number
Memory allocated to
24
printer mode
Key auto repeat
25
Key press time
26
Audible signals volume
27
Base setting beep
28
signal
Number of copies limit
29
Use close paper size
30
Default tray setting
31
Default exposure mode
32
USB 2.0 mode
33
switching
4
* AR-M160 is as follow:
1: Upper tray (factory default), 2: 250-sheet paper feed unit/Upper paper tray of 2 x 250-sheet paper feed unit,
3: Lower paper tray of 2 x 250-sheet paper feed unit, 4: Bypass tray
5
* The scanning speed increases when the USB 2.0 mode is set to "Hi-Speed", however, the printing speed does not increase
considerably.
46
Setting codes
(factory default setting
appears in bold)
1: 30%
2: 40%
3: 50%
4: 60%
5: 70%
0: OFF
1: ON
1: Minimum
(current response speed)
2: 0.5 sec.
3: 1.0 sec.
4: 1.5 sec.
5: 2.0 sec.
1: Low
(current volume)
2: High
3: OFF
0: OFF
1: ON
1: 99 copies
2: 999 copies
0: OFF
1: ON
1: Upper paper tray*
2: Lower paper tray*
3: 250-sheet paper feed
unit/
Upper paper tray of 2
x 250-sheet paper*
feed unit
4: Lower paper tray of 2
x 250-sheet paper
feed unit*
5: Bypass tray*
1: AUTO
2: TEXT
3: PHOTO
1: Full-Speed
*5
2: Hi-Speed
• Use this to change the proportion of machine
memory used for printer mode.
• Use this setting to select whether or not holding
down a key causes repeated input of the key.
For keys that normally cause a set value to
increase when held down (for example, holding
down the [ZOOM] key (
can be used to have the set value not change
when the key is held down.
• Use this setting to select how long a key must
be pressed for the input to be accepted. By
selecting a longer time, you can prevent
settings from being changed by the accidental
pressing of a key.
• This sets the volume of beep signals. (p.47)
• Use this to sound a beep when a base setting is
selected. (p.47)
• Use this setting to select 99 or 999 for the
maximum number of copies.
• When this function is enabled, printing in printer
mode will automatically continue using a
different size of paper if the specified size of
paper runs out in all trays. This feature does not
function in copy mode.
4
4
• Use this program to select a default tray. This
tray is automatically selected each time the
4
power is turned on or each time the machine
reverts to the initial settings.
4
4
• Use this program to set "AUTO", "TEXT", or
"PHOTO" as the default exposure mode.
This sets the USB 2.0 data transfer speed. To
obtain the fastest speed when using the USB 2.0
port, first verify that your computer meets the
system requirements (operating system and
driver), and then use this program to change the
USB 2.0 mode to "Hi-Speed". Note that the setting
should not be changed while running a TWAIN
driver. (For the system requirements, see "System
requirements for USB 2.0 (Hi-Speed mode)"
(p.38).)
Explanation
)), this program
,