Table of Contents
Advertisement
APPENDIX
Problem:
Picture is T/B inverted.
Picture is L/R Reversed.
Some displays are not seen
during the operation.
No sound.
Remote control unit doesn't
work.
Wireless mouse function
does not work.
SERVICE
WARNING: High voltages are used to operate this
projector. Do not attempt to open the cabinet.
You can often correct operating problems yourself. If the
projector fails to work properly, see "TROUBLESHOOTING"
section on page 53, 54. To correct the failure, try the
"Solutions".
The CE Mark is a Directive conformity mark of the European
Community (EC).
54
Check Reverse T/B feature.
(See "SETTING" section on pages 48 ~ 49).
Check Reverse L/R feature.
(See "SETTING" section on pages 48 ~ 49).
Check Display feature.
(See "SETTING" section on pages 48 ~ 49).
Check audio cable connection from audio input source.
Adjust audio source.
Press the VOLUME (+) button.
Press the MUTE button.
Check the batteries.
Make sure nothing is blocking between the remote control sensor and remote
control unit.
Make sure you are not too far from the projector when using the remote control
unit. {Maximum operate range 16.4 ' (5 m)}.
Check the transmitted signal mode from the remote control unit.
(See "SETTING" section on pages 48 ~ 49).
Check the cable connection between the projector and the computer.
Check the mouse setting on your computer.
Turn on the projector before you turn on the computer.
If after following all operating instructions, you find that
service is necessary, contact the Sanyo Service Station or
the store where you purchased the unit.
Give the model number and explain the difficulty. We will
advise you how to obtain service.
This symbol on the nameplate means the product is Listed by Underwriters
Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety
standards against risk of fire, casualty and electrical hazards.
Try these Solutions:
Advertisement
Table of Contents
