Sanyo PLC - 12BL Owner's Manual page 27

Remote Control Battery Installation
1
Remove the battery
compartment lid.
Using the Remote Control Unit
Point the remote control toward the projector (Receiver window) whenever pressing the buttons. Maximum operating range
for the remote control is about 16.4' (5m) and 60° front and rear of the projector.
To insure safe operation, please observe the following precautions :
Use (2) AA type alkaline batteries.
Change two batteries at the same time.
Do not use a new battery with a used battery.
Avoid contact with water.
Do not drop the remote control unit.
If batteries have leaked on the remote control,
carefully wipe the case clean and load new batteries.
2
Slide the batteries into the
compartment.
Note : For correct polarity (+ and -
terminal), be sure the battery
terminals are in contact with the
pins in the compartment.
16.4'
(5 m)
60°
BEFORE OPERATION
3
Replace the compartment lid.
16.4'
(5 m)
60°
27