Touchview User Interface - Korg KRONOS2-61 Quick Start Manual

TouchView user interface

Mode name
a: Current page
b: Category popup button
c: Popup button
d: Edit cell
e: Knob
f: Slider
g: Page tab
h: Page group tab
The KRONOS uses Korg's TouchView graphical user
interface. By touching objects displayed in the LCD screen,
you can select pages, set parameter values, move sliders and
knobs, enter text, connect virtual patch cables, and more.
Important - calibrate before using!
Make sure to calibrate the touch-screen before using, or
when you change the angle of view (for instance, when you
move between sitting and standing):
1. Press the GLOBAL button to go to the GLOBAL
P0:BASIC SETUP page.
2. Press the page menu button to open the menu, and
select the Touch Panel Calibration command.
3. Follow the on-screen instructions, and press the Done
button when complete.
For best results, calibrate using a stylus (not included) or
fingernail, and press the exact centers of the calibration
boxes.
a: Current page
From the left, the top of the display shows the current mode,
the number and name of the page group, and finally the
name of the individual page.
b: Category popup button
When you press this button, a tabbed popup menu will
appear, allowing you to select Programs, Combinations, or
GEs organized by category.
Page group number and name
c: Popup button & menu
When this button is pressed, a popup menu will appear,
showing a list of options. In some cases, these will be
parameter values. In others, they may be lists of items, such
as Multisamples or FX Presets. To enter a parameter value,
touch the desired value.
Pin
Many popup menus have a "Pin" in the
upper left. This controls what happens after
you select a value. Touch the pin graphic to
switch between open (unlocked) and closed
(locked).
When locked (pin closed), the popup menu will remain
displayed even after you select a parameter value. To close
the popup, either unlock the pin, or press EXIT.
When unlocked (pin open), the popup menu will close
immediately when you press a parameter value, or when you
touch the screen outside the menu.
d: Edit cell
When you touch a parameter in the LCD screen, the
parameter or its value will usually be highlighted (displayed
in inverse video). This is called the edit cell, and the
highlighted item is now selected for editing.
The parameter value of the edit cell can be modified using
the VALUE controllers. Alternatively, you can edit the value
by touching the edit cell and dragging your finger up or
down. If your hand is obscuring the parameter value on the
screen, you can drag your finger to the left or right before
editing; as long as you don't lift your finger from the screen,
the parameter will stay selected.
TouchView user interface
i: Check-box Page name j: Page menu button
Pin
13
En-