Sanyo PDP-42H2A Owner's Manual page 9

INSTALLATION OF OPTIONAL SPEAKERS AND STAND
Speakers and stands to upgrade your Plasma Monitor are provided separately. Please read the each
option's instruction manual (or installation manual) for more detail on the installation.
Speakers (Optional)
Left Speaker
Small Screws
(2pcs)
Right Speaker
Table Top Stand (Optional)
Speaker
Screws (3pcs)
Speaker
CAUTION IN INSTALLATION
Through installation work, handling with more than two people is recommended.
When holding (moving or lifting) the Plasma Monitor, hold the Monitor's body. Do not handle it by
holding the attached accessory parts (the Speakers), otherwise damage could be result.
Leave the sufficient space for the installation work. The surface must be flat and maintained with soft
material (cloth or blanket) for protecting the screen surface.
Before placing the Plasma Monitor Screen facing down, make sure there is no object under the screen.
Leaving any object may cause damage on the screen surface.
Place the Speakers to each side of the Plasma
Monitor and attach Right and Left brackets with the
specified screws. Mount each screw on proper screw
hole position and fix it securely.
Connect the red wire to the red terminal on both of
the Plasma Monitor and the speakers and connect
Small Screws
the black wire to the black terminal to make correct
(2pcs)
polarity.
Soft Cloth
Screws (3pcs)
Assemble Table top stand according to the
installation manual of the stand.
Mount the stand on the back of the Plasma Monitor
by fixing the Arms with screws (3 pcs. for each
arm).
Table Top Stand
PREPARATION
9