Operating Range; Remote Control Batteries Installation - Sanyo PDP-42H2A Owner's Manual

Point the Remote Control Unit toward the Plasma
Monitor (Infrared Remote Receiver) whenever
pressing the buttons. Maximum operating range for
the Remote Control Unit is about 16.4' (5m) and 60°
in front of the Plasma Monitor.

REMOTE CONTROL BATTERIES INSTALLATION

Remove the battery
1
compartment lid.
OPEN
Press the lid
downward
and slide it.
To ensure safe operation, please observe the following precautions :
Use (2) AA, UM3 or R06 type alkaline batteries.
Replace two batteries at the same time.
Do not use a new battery with a used battery.
Avoid contact with water or liquid.
Do not expose the Remote Control Unit to moisture, or heat.
Do not drop the Remote Control Unit.
If batteries have leaked on the Remote Control Unit, carefully wipe the case clean and load new
batteries.
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.

OPERATING RANGE

OK
– +
MENU INPUT VOLUME
Slide 2 batteries into
2
the compartment.
Two AA size batteries
For correct polarity (+ and –), be sure
the battery terminals are in contact
with pins in the compartment.
BEFORE OPERATION
4
60°
16.4' (5 m)
Replace the compartment
3
lid.
OPEN
Slide the lid
upward.
17