Whirlpool W10254428A Manual page 8

FOR SERVICE TECHNICIAN'S USE ONLY
FAULT/ERROR CODES (continued) — The fault codes below may be indicated
under various conditions and can be accessed through Service Diagnostics.
Display EXPLANATION AND RECOMMENDED PROCEDURE
F5E2 DOOR LOCK ERROR
At the start of a cycle, the washer attempts to lock the door 6 times. If door cannot be locked, the washer
goes into pause mode and code is generated. This code is available only in service mode.
Possible Causes
T
F5E3 DOOR UNLOCK ERROR
At the start of a cycle, the washer attempts to unlock the door 6 times. If door cannot be unlocked, the washer
goes into pause mode and the code is generated. This code is available only in service diagnostics.
Possible Causes
Verify door latch is secured to front panel.
T
F6E1 COMMUNICATION ERROR BETWEEN CCU AND MCU
Possible Causes
Ve
T
T
F6E2 COMMUNICATION ERROR UI TO CCU
F6E3 COMMUNICATION ERROR CCU TO UI
Possible Causes
Ve
T
F6E5 COMMUNICATION ERROR BETWEEN CCU AND EB
there is no bulk dispensing, presence, or level information. This error code is not displayed during operation;
however, when the fault occurs, the washer pauses.
Possible Causes
Ve
T
F7E1 DRIVE MOTOR TACHOMETER ERROR / WASHER OVERLOAD
Possible Causes
sher is overloaded.
Verify that the shipping system, including shipping bolts and spacers, is removed.
T
F7E2 MCU FAULT OR MOTOR OVERHEAT
to cool down before restarting.
Possible Causes
Improper installation of washer. Ensure that washer is not located near a heat source and has proper ventilation.
F8E0 STEAM INLET VALVE ERROR
This error is displayed when the steam valve malfunctions. This error can be seen only in service diagnostics.
Possible Causes
PAGE 8
.
.
.
T
.
T ater Inlet Va
DO NOT REMOVE OR DESTROY