Checking The Water Pressure; Checking The Expansion Vessel; Checking The Flue Gas Discharge And The Air Supply; Checking The Combustion - Baxi 224 Combi 2 Installation And Service Manual

10 Maintenance
Fig.72 Dismantling the siphon
3
2
A
4
5
66 Combi 2
10.3.2

Checking the water pressure

In order for the boiler to operate correctly, the pressure of the water in the
heating circuit, shown on the
bar. If necessary, restore the water pressure as described in the chapter
entitled "Filling the installation".
10.3.3

Checking the expansion vessel

Check the expansion vessel and replace it if necessary. Check its
pre-charge every year and restore the pressure to 1 bar if necessary.
10.3.4

Checking the flue gas discharge and the air supply

Check the entire line of flue gas pipes, in particular the tightness of the
flue gas evacuation and combustion air intake connections.
10.3.5

Checking the combustion

Measure the O
flue gas measuring point. To do this, proceed as follows:
Heat the water in the boiler to a temperature of approx. 70°C.
Unscrew the plug of the flue gas measurement point (exhaust system
adaptor).
Measure the content of O
equipment. Compare this with the control value.
10.3.6

Checking the automatic air vent

Check that the boiler pump venting valve is working. In the event of a leak,
replace the valve.
10.3.7

Cleaning the siphon

The front panel must be removed to extract the siphon (A). Proceed as
described below:
Lower the panel (1);
Remove the clip (2);
Unfasten the pipe from the heat exchanger (3);
Remove the siphon (4) and clean it;
1
Replace, if necessary, all the gaskets present;
Fill the siphon with water and reposition it in its seat (5).
BO-0000208
display, must be between 1.0 and 1.5
/CO contents and the temperature of the flue gases at the
2 2
/CO in the flue gas using the measuring
2 2