Wall Bracket Assembly - Samsung SyncMaster P50HP User Manual

Wall Bracket Assembly

Note
There are two hinges(left and right). Use the correct one.
1. Insert and tighten the Captive Screw in the direction of the arrow.
When done, mount the wall bracket on the wall.
A -
B -
C -
D -
2. Before drilling into the wall, check if the length between the two locking holes at the back
of the product is correct.
If the length is too short or long, loosen all or some of the 4screws on the wall bracket to
adjust the length.
A -
3. Check the installation diagram and mark the drill points on the wall. Use the 5.0 mm bit
to drill holes deeper than 35 mm. Fix each anchor in the corresponding hole. Match each
Introduction
Captive Screw
Wall Bracket
Hinge (Left)
Hinge (Right)
Length between the two locking holes
20