Assign Screen - Behringer X32 User Manual

63
X32 COMPACT DIGITAL MIXER User Manual
5. Rotate the 4th encoder to select the speci c signal source to feed the
currently selected channel of the stereo recorder. Choices include:
Main L
Main R
Main C/M
Any of the 16 Mix Bus Outputs
Any of the 6 matrix outputs
Any of the 32 direct outputs
Direct Outputs Aux 1-8
Any of the FX Direct Outputs
Monitor L
Monitor R
Talkback
6. Rotate the 5th encoder to select the signal tap point that the selected audio
path is tapped from when feeding currently selected channel of the stereo
recorder. Choices include:
Pre EQ
Post EQ
Pre-Fader
Post-Fader
7. Tap the 6th encoder to toggle the "playback folder" mode on/o .
When playback folder mode is OFF, the transport will stop after playing
the currently selected audio le. This is useful for situations like
triggering audio cues or sound e ects in a theatrical setting.
When playback folder mode is ON, the transport will continue playing
back all audio les residing in the currently selected folder one by one.
This is useful for playing back several songs during a break in the main
set, allowing the attached USB drive to act as a source for "break music".

7.12 Assign Screen

The assing screen allows setup for the eight user-assignable buttons. Using this
screen, the console operator can assign 3 sets of 8 custom controls to be available
for adjustment at all times.
The assign screen contains the following separate tabs:
Home: This screen provides a general overview of the 8 assigned controls for all
three control sets at the same time.
Set A: This screen allows assignment of di erent console parameters to the
8 custom controls for set A.
Set B: Works as described above but for custom controls set B.
Set C: Works as described above but for custom controls set C.
7.12.1 Assign Screen: Home Tab
The assign screen's "home" tab provides a visual overview of the 8 assigned
controls for all three sets at the same time.
The home tab o ers visual feedback of the controls that have been assigned to
all three sets of custom controls, without having to bank between the three sets
one-by-one or relying on the abbreviated syntax shown in the custom control's
dedicated LCD displays.
To adjust the various settings on the home tab, perform the following steps:
1. Press the Up and Down arrows to select Set A, B or C. You can also press the
1st encoder to skip to the next set.
2. Rotate encoders 2-5 to adjust the currently-assigned parameters.
3. Tap the 6th encoder to jump to the edit page for the currently selected set.