Callouts; Channel Strip And Monitoring - Behringer X32 User Manual

12
X32 COMPACT DIGITAL MIXER User Manual

2. Callouts

2.1 Channel Strip and Monitoring

!'#
!&#
!,#
!"#
!"#$ Preamp – Adjust the preamp gain for the selected channel with the
Gain knob. Press the 48 V button to apply phantom power for use with
condenser microphones and press the
phase. The meter displays the selected channel's level. Press the Low Cut
button and select the desired high-pass frequency to remove unwanted
lows. Press the View button to access more detailed parameters on the
Main Display. Note - It is best practice to mute the respective channels prior
to switching their phantom power supply on or o . Otherwise, the change
of charge may cause an audible popping noise. Gain adjustments might
also produce audible click noise when adjust shortly after having switched
phantom power on or o .
!%#$ Gate/Dynamics – Press the Gate/Ducker button to engage the noise gate
and adjust the threshold accordingly. Press the Comp/Exp button to engage
the compressor and adjust the threshold accordingly. When the signal level
in the meter drops below the selected Gate threshold, the noise gate will
silence the channel. When the signal level reaches the selected Dynamics
threshold, the peaks will be compressed. Press the View buttons to access
more parameters on the Main Display.
!&#$ Equalizer – Press the Equalizer button to engage this section. Select one
of the 4 frequency bands with the High, High Mid, Low Mid, and Low knobs.
Press the Mode button to cycle through the types of EQ available. Select the
speci c frequency to be adjusted with the Freq knob, and adjust the bandwidth
of the EQ with the Q knob. Finally, boost or cut the selected frequency with the
Gain knob. Press the View button for more editing options.
!(#) !*# !!"#
!+#
button to reverse the channel's
!$#
!%#
!'#$ USB Recorder – Connect a thumb drive to install rmware updates and to
record performances. See the Topic Guide section for details.
!(#$ Main Bus – Press the Mono Bus or Main LR Bus to assign the channel to the
main mono or stereo bus. When Main LR Bus is selected, the Pan/Bal adjusts
the left-to-right positioning. Adjust the overall send level to the Mono Bus
with the Level knob. Press the View button for more editing options.
!)#$ Talk A/B – Select the destination for the talkback mic signal with these
buttons. Press the View button to edit the talkback routing for A and B.
!*#$ Talk Level – Adjust the level of the talkback mic with this knob.
!+#$ Monitor Level – Adjust the level of the Monitor outputs with this knob.
!,#$ Dim – Press this button to reduce the monitor volume. Press the View
button to adjust the amount of attenuation along with all other monitoring-
related functions.
!"#$% Phones Level – Adjust the volume of the headphone outputs, located
inside the left and right side caps.