Casio Keyboard CDP-200R User Manual page 28

Playing Built-in Songs
Repeating Playback of Specific Measures
You can use the procedure in this section to repeat particular
measures for practice playing along until you master it. You
can specify the start measure and the end measure of the
section you want to play and practice.
Start
These measures are repeated.
1.
bk
Press to temporarily turn off song repeat
("REPEAT" disappears from the display).
2.
When song playback reaches the measure you
want to specify as the start measure, press
This specifies the measure as the start measure.
3.
When playback reaches the measure you want
to select as the end measure, press
This specifies the measure as the end measure and starts
repeat playback of the measures in the specified range.
• During repeat play you can use
bm
to skip forward, or
4.
bk
Pressing again returns to normal playback.
Changing the song number clears the start measure and
end measure of the repeat operation.
E-26
End
Flashes
bk
again.
bn
to pause playback,
bl
to skip back.
Lights
Changing Playback Speed (Tempo)
You can use the following procedure to change the speed
(tempo) in order to slow down playback to practice difficult
passages, etc.
1.
bq
Press
Use w (slower) and q (faster) to change the tempo
setting. Holding down either button changes the setting at
high speed.
• Pressing w and q at the same time will return the
current song to its original default tempo.
• Pressing
display. While the tempo value is flashing, you can use
cl
(10-key) to change it. The tempo value will stop
flashing if you do not perform any operation for a short
while.
• Changing the song number will return the song to its
original default tempo.
bk
.
Adjusting the Song Volume
Use the following procedure to adjust the balance between
the volume of what you play on the keyboard and song
playback volume.
1.
7
Press
and [6] (i) keys to display "Song Vol" (page
E-6).
2.
cl
Use the
song volume.
Playing with the Tone as Song Playback
The procedure below lets you select the same keyboard tone
as the one being used in the song and play along with your
favorite tunes.
1.
After selecting a song, hold down
two seconds until the displayed tone name
changes to the tone name of the song.
• If your currently selected tone is the same as the song
tone, the display contents will not change.
2.
Play along with song playback.
• If you select a song that uses different tones for left and
right hand play, the right hand part tone is assigned to the
keyboard.
.
bq
causes the tempo value to flash on the
cl
and then use the (10-key) [4] (u)
S o n
g
(10-key) [–] and [+] keys to adjust the
V o l
br
for about