Clearing A Clog; Troubleshooting - Bissell POWERFORCE PET DELUXE 3334 Series Manual

Clearing a Clog

We have additional tips for maintaining your machine at support.BISSELL.com.
1.
Remove the hose from
the back of the vacuum by
twisting it to the left. Remove
any debris.

Troubleshooting

Below are some of the issues you may run into. If you don't see the issue you're experiencing
below, visit support.BISSELL.com.
Problem Possible Cause
Incorrect height
adjustment.
Hose not attached
properly.
Crack or hole in hose.
Broken or worn drive
belt.
Rotating floor brush
Vacuum or
jammed.
tools won't pick
up dirt
Clog in vacuum.
Dirt tank full.
Dirt tank not installed
properly.
Filters are dirty.
Incorrect height
Vacuum is
adjustment.
difficult to push
Dirt tank full.
Visible dirt
escaping from
Filters missing or
vacuum
installed incorrectly.
Note: Any other servicing should be performed by an authorized service representative.
WARNING
before performing maintenance or troubleshooting checks.
2.
Check the foot hose on the
back. If necessary, remove the
screw from the foot hose and
check for clogs.
To reduce the risk of electric shock, turn power OFF and disconnect plug from electrical outlet
Remedies
Adjust Powerfoot to correct height setting.
Grasp the hose wand and firmly push into the hose
wand base.
Check hose and replace if needed.
Replace drive belt, see page 6.
Remove brush and clean debris from brush ends,
see page 6.
Check for debris build-up or clogs in the inner tank,
hose and foot/lower hose. See online video for more
help.
Empty dirt tank.
Position correctly and lock in place, see page 5.
Check and clean pre-motor and post-motor filters,
see page 6. Replace pre-motor filter if needed.
Adjust Powerfoot to correct height setting, see page 4.
Empty dirt tank.
Check and clean pre-motor and post-motor filters,
see page 6. Replace pre-motor filter if needed.
3.
Check the air passageway
on the bottom of your vacuum.
Remove the bottom cover and
the brush. Remove any debris.
BISSELL.com 7