Clearing A Clog - Bissell POWERGROOM 2256 Series User Manual

Replace Brush & Belt
WARNING
To reduce the risk of electric shock, turn power switch o and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
1
Unplug vacuum, turn over and unscrew
six (6) Phillips head screws to remove
the bottom cover. Lift brush straight out.
3
Belt
End Cap
Replace the brush roll and belt by looping the belt over the motor shaft and the brush
roll. Line up the end caps and pull the brush forward into place. This will stretch the
belt. Return bottom cover back on and replace the screws.

Clearing a Clog

1 2
Check the foot hose on
Remove the hose
the back of your vacuum
from the back of the
down towards the bottom.
vacuum by twisting
If necessary, remove the
it to the left. Remove
screw from the foot hose
any debris that may
and check for clogs.
have gotten clogged.
2
Clean debris from brush roll. Inspect by
placing on its end and spin. The brush
roll should spin freely, multiple times by
one flick. If it doesn't, replace brush roll.
Check belt for wear or cuts and replace
if necessary.
3
Check the air passageway on
the bottom of your vacuum.
Remove the bottom cover and
the brush. Remove any debris.
www.BISSELL.ca
9