V I I I . D I S A S S E M B L Y A N D A S S E M B L Y - Pride Victory XL Owner's Manual

V I I I . D I S A S S E M B L Y A N D A S S E M B L Y

No tools are required to disassemble or assemble your Scooter. Always choose a level, dry surface with sufficient
room for you to work and move around, and keep in mind that the disassembled sections of your Scooter take up
more floor space than the assembled unit.
DISASSEMBLY
You can disassemble the Victory XL into seven pieces: the seat, the front section, the front basket, the rear section,
the rear shroud, and the two batteries. Place the Scooter in an area where you have sufficient clearance to move
the parts around—approximately 1,5 meters in all directions. You may need assistance to lift some of the Scooter
components. See III. “Specifications” for individual component weights.
1. Remove the key from the key switch.
2. Place the manual freewheel lever in the drive (down) position.
3. Remove the seat from your Scooter.
4. Gently lift the rear shroud off of your Scooter. The rear shroud is held in place with reusable fasteners.
5. Unplug both battery harnesses. See figure 13.
6. Disconnect the battery tie-down strap, then lift both batteries from the battery wells.
7. Unplug the large, white, 9-pin front-to-rear connector that attaches the front control console harness to the
electronic controller module harness. See figure 13.
CAUTION! Failing to unplug both battery harnesses and the front-to-rear connector prior to further
disassembly could result in permanent damage to your Scooter.
8. Turn the tiller adjustment lever counterclockwise until it is loose. Pull the rubber boot upward to expose the
tiller release buttons. Place one hand on the rear of the tiller and carefully depress both tiller release buttons
while slowly lowering the tiller to the center of the floorboard.
9. Remove the locking pin from the frame. See figure 14.
10. Move the cam lock levers to the unlocked, vertical position. See figure 14.
11. Pull up on the manual freewheel lever to make it easier for you to maneuver the rear section.
12. Place one hand on the seat post tower and one hand on the front frame handle; gently slide the front and rear
sections apart. See figure 15.
BATTERY HARNESSES
FRONT-TO-REAR CONNECTOR
Figure 13. Cable Connections
26
All manuals and user guides at all-guides.com
UNLOCKED POSITION
LOCKING PIN
Figure 14. Cam Lock Levers and Locking Pin
Victory XL