Pride Victory XL Owner's Manual page 20

V . B A T T E R I E S
Use these specifications to reorder deep-cycle batteries.
Type:
Size:
Voltage:
Amperage:
To change a battery in your Victory XL:
1. Remove the seat and the rear shroud. See VIII. “Disassembly and Assembly.”
2. Remove the battery tie-down strap.
3. Disconnect the battery cables from the electronic controller module.
4. Disconnect the battery cables from the battery terminals.
5. Remove the old battery.
6. Place a new battery in the battery well.
7. Connect the red battery cable to the positive (+) battery terminal.
8. Connect the black battery cable to the negative (-) battery terminal.
9. Reconnect the battery cables to the electronic controller module.
10. Fasten the battery tie-down strap.
11. Reinstall the rear shroud and the seat.
WARNING! Battery posts, terminals, and related accessories contain lead and lead compounds.
Wash hands after handling.
Why do my new batteries seem weak?
Deep-cycle batteries employ a different chemical technology than that used in car batteries, nickel-cadmium batteries
(nicads), or in other common battery types. Deep-cycle batteries are specifically designed to provide power, drain
down their charge, and then accept a relatively quick recharge.
We work closely with our battery manufacturer to provide batteries that best suit your Victory XL’s specific
electrical demands. Fresh batteries arrive daily at Pride and are shipped fully charged to our customers. During
shipping, the batteries may encounter temperature extremes that may influence their initial performance. Heat
diminishes the charge on the battery; cold slows the available power and extends the time needed to recharge the
battery.
It may take a few days for the temperature of your Victory XL’s batteries to stabilize and adjust to their new room
or ambient temperature. More importantly, it takes a few charging cycles (a partial drain followed by a full recharge)
to establish the critical chemical balance that is essential to a deep-cycle battery’s peak performance and long life.
Please follow these steps to properly break in your Victory XL’s new batteries for maximum efficiency and service life.
1. Fully charge any new battery prior to its initial use. This initial charging cycle brings the batteries up to about
88% of their peak performance level.
20
All manuals and user guides at all-guides.com
Battery Specifications
Deep-cycle (sealed lead-acid or gel cell)
U-1
12 volts each
32 AH, 40AH, 45AH, or 55AH
A N D C H A R G I N G
Victory XL