Table of Contents
Advertisement
All manuals and user guides at all-guides.com
Getting Started
Note: In this User Manual, "press a key"
back of the handset. Push the cover in an
means to press the key and release it, while
upward motion until you hear a click.
"hold a key" means to press the key for at
least two seconds and then release it.
Battery
The included lithium ion battery can be used
immediately after unpacking.
Removing the Battery
Installing the Battery
1. Make sure that your mobile phone is
1. Remove the battery cover by turning the
switched off.
phone upside down, pressing down on
2. Remove the battery cover as directed.
the upper portion of the battery cover, and
pushing the cover in a downward motion.
3. Pull the battery up and remove it from
the mobile phone.
2. Insert the battery by aligning the gold-
colored contacts with the contacts in
the battery slot.
Charging the Battery
3. Push down the upper section of the
Your phone is powered by a rechargeable
battery until it becomes flush with
lithium ion battery. For maximum battery
the handset.
performance, it is recommended that you
fully discharge the initial charge and then
4. Replace the battery cover by aligning the
charge it completely. A new battery's full
tabs on the upper portion of the cover
performance is achieved only after three
with the slots on the upper portion of the
complete charge and discharge cycles.
2
1. Connect your travel adapter to the
2. Turn the phone over and remove the
side of your mobile phone as shown in
battery cover.
the diagram.
3. Remove the battery if it is already
2. The battery charging indicator will
installed.
appear.
4. Hold your SIM card with the cut corner
3. Once the battery is fully charged,
oriented as shown on the handset. Slide
disconnect the charger.
it into the card holder with the gold-
colored contacts facing downward.
5. Replace the battery.
6. Replace the battery cover.
Battery charging time
Your battery can be fully charged in three
hours. Do not charge your battery for more
than six hours.
Inserting the SIM Card
What is a SIM card?
Before you can begin operation of your
Your mobile phone has a Subscriber Identity
mobile phone, you need to insert the
Module (SIM) card. This is a microchip that
SIM card that was provided by AT&T. Full
holds your personal information, such as
functionality of your device can only be
names and phone numbers. Your phone
ensured when the AT&T SIM card is
will not function properly without it. If you
inserted properly.
already have contacts on your SIM card,
Insert the SIM card as follows:
they can be transferred in most cases.
1. Make sure that the phone is switched
off and the charger is disconnected from
the phone.
Getting Started
3
Advertisement
Table of Contents
