Repeatedly Playing A Specified Region-The Repeat Function; Registering The Repeat Region; Canceling The Registration - Roland DiscLab CDX-1 Owner's Manual

Recording/playing back a performance
Repeatedly playing a specified region
—the Repeat function
By using the Repeat function you can repeatedly play back a specified region. This
is convenient when you wish to check the mix balance over and over.

Registering the repeat region

1. Turn the TIME/VALUE dial or press REW [
location where you wish to begin repeating.
2. Press REPEAT [
REPEAT [
registered as the repeat start point (A).
fig.2-04
If you wish to re-do the registration, press REPEAT [
is the same as the repeat start point (A), and the registration will be cancelled. If the
current location is past the repeat start point (A), press REPEAT [
cancel the registration.
3. Turn the TIME/VALUE dial or press REW [
location where you wish to stop repeating.
4. Press REPEAT [
REPEAT [
registered as the repeat end point (B).
fig.2-05
If you wish to re-do the registration, press REPEAT [
registration, and then re-register, starting with the repeat start point (A).
5. When you press PLAY [
registered will play repeatedly.

Canceling the registration

1. When REPEAT [
REPEAT [
repeat start point (A) and end point (B) registrations will also be erased.
128
].
] will blink, indicating that the current location has been
].
] will light, indicating that the current location has been
], the region between the (A) and (B) points you
] is lit, press REPEAT [
] will go out. The Repeat function will be cancelled, and the
] /FF [ ] to move to the
] if the current location
] twice to
] /FF [ ] to move to the
] to cancel the
] once again.
The Repeat function and
Punch-in/out recording
cannot be used together.
If you want to repeat at the
location of a marker, move to
the location of that marker in
steps 1 and 3 before you
register the repeat start/end
points. "Moving to a
location of a marker" (p. 129)
There must be at least one
second between the repeat
start (A) and end (B) points. Is
not possible to set the end
point less than one second
away from the start point.