Pyrolytic (On Some Models Only) - Smeg SOA6101TS Manual

by opening the door or pressing/turning
one of the two knobs.
7. Turn the function knob to 0 to exit from the
function.
Programmed Vapor Clean cycle
It is possible to program the Vapor Clean
function start time, like all other cooking
functions.
1. After having selected the Vapor Clean
function, turn the temperature knob (the
indicator light
at which you want the Vapor Clean function
to end.
2. Wait 3 seconds before confirming the
settings.
The appliance waits until the set start time to start
the Vapor Clean function.
Vapor Clean End
1. Turn the function knob to 0 to exit from the
function.
2. Open the door and wipe away the less
stubborn dirt with a microfibre cloth.
3. Use a non-scratch sponge with brass
filaments on hard to remove deposits.
4. In case of grease residues use specific oven
cleaning products.
5. Remove the residual water inside the oven.
6. Replace the self-cleaning panels and the
rack/tray support frames, if fitted.
For greater hygiene and to avoid foods taking
on unpleasant odours:
• We recommend drying the inside of the
oven with a fan assisted function at 160°C
for around 10 minutes.
• If self-cleaning panels are fitted, we
recommend that you dry the inside of the
oven with a simultaneous catalytic cycle.
We recommend wearing rubber gloves
for these operations.
91477A235/A
comes on) to set the time
We recommend removing the door in
order to make the manual cleaning of
the parts that are difficult to reach
easier.

Pyrolytic (on some models only)

See General safety instructions.
Pyrolytic cleaning is an automatic high-
temperature cleaning procedure which
causes dirt to dissolve. This process
makes it possible to clean the inside of
the oven very easily.
Preliminary operations
Before starting the pyrolytic cycle:
• Clean the internal glass pane following the
usual cleaning instructions.
• Remove any food residues or large spills
from previous cooking operations from the
inside of the oven.
• Completely remove all accessories from
inside the oven.
• For very stubborn encrustations spray an
oven cleaning product onto the glass (read
the warnings on the product); leave for 60
minutes, then rinse and dry the glass using
kitchen roll or a microfibre cloth.
• If present, remove the temperature probe.
• Remove the rack/tray support frames.
• Close the door.
Pyrolytic function setting
1. After entering the special functions menu,
turn the temperature knob until the Pyrolytic
function is selected.
2. Press the temperature knob to confirm the
function.
The display shows the Pyrolytic cycle duration
CLEANING AND MAINTENANCE - 27