Trane Link UX360 Installation Manual page 10

Installation Guide
Sub Menu Menu Selection
Heating Aggressive
Recovery Setting (°F)
General
System
Operation
Smart Control Fan
Enable Status
System SC360 Installed in
Controller Conditioned Space
Heater Type
Heater Size
Indoor Heat
Heater Model Number
Heater Serial Number
Cycles Per Hour
Electric Heat Airflow
Blower On Delay
Blower Off Delay
Compressor Minimum System
Operation Speed
Cycles Per Hour
Blower Off Delay
Compressor
Blower On Delay
Cooling
Minimum Indoor Coil
Temp (°F)
Maximum Indoor Coil
Temp (°F)
10
Options [Default]
0°F -70°F [40°F]
Enabled/[Disabled]
Yes/[No]
[None]/Electric/
Hydronic
Electric: [Empty List]/
25KW, 1-Phase/
20KW, 1-Phase/
15KW, 3-Phase/
15KW, 1-Phase/
10KW, 3-Phase/
10KW, 1-Phase/
8KW, 1-Phase/ 4KW,
1-Phase/
5KW, 1-Phase
Hydronic:
100Kbtu/80Kbtu/
70Kbtu/50Kbtu
[NOMODELNUM]
[NOSERNUM]
2-6 CPH [5]
[Low]/Med/High
No delay/15/30/45/[60]
seconds
No delay/30/[50]/70/90
seconds
[Factory]/
30%/40%/50%
2-6 CPH [3]
[No Delay]/Auto/
30 seconds
[No Delay]/Auto/
30 seconds
28°F -60°F [30°F]
28°F -60°F [55°F]
Description
Select the outdoor temperature for
Heating Aggressive Recovery.
Select to enable or disable Smart
Continuous Fan.
Enable if the SC360 was installed in a
conditioned space and can be used as an
indoor temperature and humidity sensor.
Select the type of indoor unit
installed. Value is pre-populated for
communicating equipment.
Select the size of the indoor unit based
on tonnage and heater type. Options
vary depending on heater type.
Value is pre-populated for
communicating equipment.
Value is pre-populated based on heater
size, but can also be manually configured.
Enter the 10-digit serial number of the
indoor unit.
Select to enable or disable the blower
on delay in hydronic heating.
Select to enable or disable the blower
off delay in hydronic heating.
Select to enable or disable the blower
off delay in compressor cooling.
Select to enable or disable the blower
on delay in compressor cooling.
18-HD98D1-1B-EN