Hitachi CPX380W Service Manual page 28

#6261
Fan for B panel
Connect this to the
Drive board E801.
#6260
CNRM
Remote PCB control cable
Connect this to the
ESPL
Drive board E806.
#6270
Fan for R panel
Connect this to the
Drive board E803.
E803
E802
#6261
Fan for G panel
Connect this to the
Drive board E802.
Drive PCB
Connect the panel flexible cable to the flexible connector.
To R: P501 To G: P601 To B: P701
Pull the hinge out in the direction
of arrow mark.
Insert the flexible cable beneath
the hinge.
Press in the hinge in the direction
of arrow mark.
Procedures
Before mounting the Drive PCB, connect the CNBAR and the CNPOW to a connector
on the back of the PCB in a state where you hold the Drive PCB with your hands.
Connect the other cables in a state where the Drive board is mounted.
Fan for lamp
Connect this to the
Drive board E808.
E302
E801 E808
E806
P601
CNBAR
Hinge
Ballast control wire cable
Connect this to the
Drive board E805.
Flexible cable
Thermistor cable
Connect this to the
Drive board E302.
Pass the cable of #3030 exhaust fan through
the fan guide as shown in the diagram, fold it back,
CNTH
and then pass it through the guide again.
ESPR
E807
I101
Power unit (Circuit) cable
CNPOW
Connect this to the
Drive board E800.
TAP4
Affix the TSW cable on the fan with a tape.
At the time, use caution not to let the two TSW
cables overlap each other underneath the tape
(so that the upper case will not swell).
Pass the #3030 exhaust fan cable and the TSN cable
through a notch (lower part) of the lamp house as
shown in the diagram.
#3030
Exhaust fan
Connect this to the Drive board E804.
Lamp door switch cable
CNLC
Connect this to the
Drive board E807.
Use a tape and temporarily stop the sag
TAP2
of CNLC on I101 of the Drive PCB
(so that it will not be caught in while the
upper case is installed).