Hitachi CPX380W Service Manual page 19

Loading the Batteries
Install the AA batteries into the remote control transmitter.
1. Remove the battery cover.
Push the knob while lifting up the battery cover.
2. Loading the batteries.
Make sure the plus and minus poles are correctly oriented.
3. Close the battery cover.
CAUTION
Use only the specifi ed batteries with this remote control transmitter. Also, do not mix new and old
batteries. This could cause in battery cracking or leakage, which could result in fi re or personal injury.
When loading the batteries, make sure the plus and minus terminals are correctly oriented as
indicated in the remote control transmitter. Incorrect orientation could cause battery cracking or
leakage, which could result in personal injury or pollution of the surrounding environment.
When you dispose the battery, you should obey the law in the relative area or country.
Keep the battery away from children and pets.
When not to be used for an extended period, remove the batteries from the Remote control transmitter.
NOTE: Replace the batteries when remote control transmitter operation becomes difficult.
Lamp (Option Lamp: DT00431
Contact your dealer before replacing the lamp.
Before replacing the lamp, switch power OFF, remove the power cord from the power outlet, and wait
approximately 45 minutes until the lamp has cooled. The lamp may explode if handled at high temperatures.
WARNING
For disposal of used lamp, treat according to the instruction of community authorities.
Since the lamp is made of glass, do not apply shock to it and do not scratch it.
Also, do not use old lamp. This could also cause explosion of the lamp.
Premature lamp failure MAY be caused by an electronic component in the projec-
tor and not necessarily the lamp. If unsure contact your local service centre.
If it is probable that the lamp has exploded (explosive sound is heard),
disconnect the power plug from the power outlet and ask your dealer to
replace lamp. The lamp is covered by front glass, but in rare cases, the
refl ector and the inside of the projector may be damaged by scattered broken
pieces of glass, and broken pieces could cause injury when being handled.
Do not use the projector with the lamp cover removed.
Lamp Life
Projector lamps have a fi nite life. The image will become darker, and hues will become weaker, after a lamp has
been used for a long period of time.
Replace the lamp if the LAMP indicator is red, or the CHANGE THE LAMP message appears when the projector is
switched ON.
NOTE: The LAMP indicator is also red when the lamp unit reaches high temperature. Before replacing the lamp,
switch power OFF, wait approximately 20 minutes, and switch power ON again.
If the LAMP indicator is still red, replace the lamp.
{CP-X380W} : DT00432 {PJ750-2}
1
)
HIGH VOLTAGE
HIGH TEMPERATURE
HIGH PRESSURE
Refl ector
PJ750-2
CP-X380W
2
Lamp
Front
glass
19