Troubleshooting - RIDGID SeeSnake nanoReel Quick Start Manual

SeeSnake nanoReel Quick Start Guide

Troubleshooting

Problem Probable Fault Location Solution
Check power cord is correctly
No power to SeeSnake
plugged in.
CCU or micro CA-300
Check the switch on monitor/
camera monitor connector
display unit.
Check alignment and pins of
connection to nanoReel system
unit from CCU or display unit.
Camera image
Connections faulty
not seen
Check orientation, seating, and
pin condition in the SeeSnake
connection.
Set video source as described in
Monitor set to wrong
display unit
source
operator's manual.
Batteries low Recharge or replace batteries.
Check source setting of monitor
"SOS" code
No video signal and
blinking on LCD*
re seat cable connection.
* The light on the LCD will only blink the "SOS" code on some SeeSnake CCUs.
4 – English