Table of Contents
Advertisement
Installation
Figure 61.
4. Replace the front panel of the pedestal base.
Figure 62.
46
Panel Power Wiring
NOTICE
Compressor Damage!
Before connecting power wire to the motor terminals,
with the motor terminal jumpers removed, verify
proper phasing between the drive and motor terminals
with an Ohmmeter for all connections. Improper
phasing occurs between the drive and motor terminals
can cause compressor damage.
5. After verifying proper phasing between the drive and
motor terminals with an Ohmmeter, install power wire
at the breaker/terminal according to the provided
schematics. Refer to
Figure 42, p. 39
designations.
6. Output wire from the drive to the motor terminals
needs to be routed through the center of the provided
cores. Install power wire at the motor terminals
according to the provided schematics.
to confirm phase
AFDR-SVN001D-EN
Advertisement
Table of Contents
