IBM Eserver 345 Series Option Installation Manual page 41

4. Remove the air baffle from the empty microprocessor socket. Store it in a safe
place for future use. An empty microprocessor socket must contain an air baffle.
5. Install a VRM in the VRM connector (J5). See the illustration at the beginning of
these instructions for the location of the connectors:
a. Center the VRM over the connector. Make sure that the VRM is oriented
and aligned correctly.
b. Carefully but firmly push down the VRM to seat the VRM in the connector.
c. Insert one end of the retainer clip on the side of the connector and fit the
retainer clip over the VRM. Insert the free end of the retainer clip on the
other side of the connector.
6. Locate the second microprocessor socket (connector J6) on the system board.
Chapter 2. Installing options
29