Advertisement
in a
AUTO mode will automatically select cooling,
heating(cooling only models without) or fan
only operation depending on what temperature
you have selected and the room temperature.
The air conditioner will control room temperature
automatically based on the temperature point set
by you.
Do not put the duct in a window.
Other Features
FOLLOW ME/TEMP SENSING feature (some models)
NOTE:This feature can only be activated from the
remote control. The remote control serves as a
remote thermostat, allowing for precise
temperature control at its location.
To activate the Follow Me/Temp Sensing feature, point
the remote control at the unit and press the Follow Me/
Temp Sensing button. The remote control will send this
signal to the air conditioner until the Follow Me/Temp
Sensing button is pressed again. If the unit does not
initiate the Auto-off stop program and illuminate the
TIMER OFF indicator light. Press the up or down
button to select the desired time. Press the TIMER
button again within 5 seconds to initiate the Auto-on
start program and illuminate the TIMER ON indicator
light. Press the up or down button to select the
desired Auto-on start time.
When the unit is off, press the Timer button to initiate
the Auto-on start program. Press it again within 5
seconds to initiate the Auto-off stop program.
Press or hold the up or down button to change the
Auto time in half-hour increments up to 10 hours,
then in 1-hour increments up to 24 hours. The
control will count down the time remaining until
start.
The system will automatically revert back to display
the previous temperature setting if there is no
operation in a 5-second period.
Turning the unit on or off at any time or adjusting
the timer setting to 0.0 will cancel the Auto Start/
Stop timer program.
Press this button to increase (cooling) or decrease
(heating) the selected temperature by 1°C/2°F (or
1°F) in 30 minutes.The temperature will then increase
(cooling) or decrease (heating) by another 1°C/2°F(or
1°F) after an additional 30 minutes. This new
temperature will be maintained for 7 hours before it
returns to the originally selected temperature. This
ends the Sleep/Eco mode and the unit will continue
to operate as originally programmed.
receive the Follow Me/Temp Sensing signal during
any 7-minute interval, the unit will exit the Follow
Me/Temp Sensing mode.
If the unit breaks off unexpectedly due to the power
being cut, it will restart with the previous function
setting automatically when the power resumes.
Advertisement
