Advertisement
Quick Links
61-140
Package Contents
User's Guide
• Wireless Door Chime
• Nylon lanyard
• Bell 1
• Bell 2
• Remote Mounting Bracket (2)
Wireless
• M 3 Screw (4)
• Anchor (5)
Two-Bell Door Chime
• M 2.6 Brass Screw (2)
• M 3.5 Screw (5)
• User's Guide
• Quick Start
1
Select Channels
1. Remove the battery compartment covers on the door
chime and the two bells.
2. Select the same channel (1, 2, or 3) in the door chime and
doorbell 1.
3. Repeat step 2 for the doorbell 2.
Bell 1
Door Chime
Channel Switch
Must be set to
same channel
n
Notes:
•
Remove batteries and follow above steps to change
Thank you for purchasing your Two-Bell Door Chime from
or reset the channel on your door chime and remote
RadioShack. Please read this user's guide before installing,
doorbells.
setting up, and using your new door chime.
2
2/2
3
•
If your door chime rings when no one presses one of the
remotes, you may be receiving interference. Switch the
affected door chime and doorbell to another channel.
You can mount your door chime on a door or wall, or set it on a
flat surface using the attached metal stand. To mount to a door
2
Install Batteries
or wall:
1. Drill a ¼ inch hole in the door or wall and insert an anchor.
1. Insert three C batteries
2. Screw an M 3.5 screw into the anchor, leaving the head
in your door chime as
indicated by the polarity
symbols (+ and – ).
3. Align the door chime's rear keyhole slot to the screw head
2. Insert three AAA batteries
in each remote doorbell as
indicated by the polarity symbols
(+ and – ).
3. Replace the covers.
Notes:
•
Replace the door chime's batteries
if it buzzes and the LED flashes red.
Bell 2
•
Replace the doorbell's batteries if
the LED turns off.
•
Use only fresh batteries of the required size and type.
•
Dispose of old batteries promptly and properly. Do not
4
burn or bury batteries.
•
Do not mix old and new batteries, different types
1. Mark two holes using the mounting bracket as a guide. Drill
of batteries (standard, alkaline, or rechargeable), or
rechargeable batteries of different capacities.
Channel Switch
2. Align your mounting bracket with the anchors and screw a
•
If you do not plan to use the alarm for a month or longer,
Must be set to
remove the batteries. Batteries can leak chemicals that can
same channel
destroy electronic parts.
3. Slide your doorbell into the bracket. To lock the doorbell in
3
Mount Your Door Chime
extended about
/
inch.
1
8
- OR -
and slide the chime down to lock in place.
You can also use the supplied lanyard to carry your doorbell
- OR -
with you as a panic alarm or to let someone know you have
arrived.
1. Slip the small end through the hole at the top of the
remote doorbell.
2. Thread the thick end through the loop at the thin end and
pull through.
Mount Your Doorbell
5
Use Your Door Chime
a ¼ inch hole at each mark. Insert an anchor in each hole.
1. Slide your door chime to ON.
2. Press the button on one of your doorbells. Your
supplied M 3.5 screw into each anchor.
chime will "ding dong" for doorbell 1 and play
"Home Sweet Home" for doorbell 2.
place, insert a supplied M 2.6 screw into the bottom of the
3. Slide the door chime to OFF when you don't
mounting bracket.
want to hear it ring.
4
5
Add Another Alarm
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
You can expand your doorbells to sound an
• Increase the separation between the equipment and receiver.
additional alarm. To do this, you will need to wire
• Connect the equipment into an outlet on a circuit different from that to
one or both doorbells to an alarm that contains a
which the receiver is connected.
• Consult your local RadioShack store or an experienced radio/TV technician
normally open contact.
for help.
1. Connect both tips of a 2-conductor wire (not
If you cannot eliminate the interference, the FCC requires that you stop
supplied) to a doorbell, as shown, using two
using your equipment. Changes or modifications not expressly approved by
RadioShack may cause interference and void the user's authority to operate
M3 screws.
the equipment.
2. Connect both tips of the other end of the
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
2-conductor wire to the extra alarm.
and (2) This device must accept any interference received, including interfer-
Now, when you press your doorbell, both the door
ence that may cause undesired operation.
chime and the alarm will sound.
Limited Warranty
Specifications
RadioShack warrants this product against defects in materials and workman-
ship under normal use by the original purchaser for ninety (90) days after
Frequency . ............................................. 433.92 MHz ± 600 KHz
the date of purchase from a RadioShack-owned store or an authorized
Doorbell current consumption ..................................... <10 mA
RadioShack franchisee or dealer. RADIOSHACK MAKES NO OTHER
Chime current consumption ........................ <2 mA @ standby
EXPRESS WARRANTIES.
........................................................................<130 mA @ chime
This warranty does not cover: (a) damage or failure caused by or attribut-
able to abuse, misuse, failure to follow instructions, improper installation or
Chime battery low ................................................. 2.4 V ± 0.1 V
maintenance, alteration, accident, Acts of God (such as floods or lightning),
Chime audio power . ......................... > 80 dBA @ 10 in (25 cm)
or excess voltage or current; (b) improper or incorrectly performed repairs
Doorbell operating temperature.......................–4° F to 140° F
by persons who are not a RadioShack Authorized Service Facility; (c)
...........................................................................(–20° C to 60° C)
consumables such as fuses or batteries; (d) ordinary wear and tear or cosmetic
damage; (e) transportation, shipping or insurance costs; (f) costs of product
Specifications are subject to change and improvement without notice.
removal, installation, set-up service, adjustment or reinstallation; and (g) claims
Actual product may vary from the images found in this document.
by persons other than the original purchaser.
Should a problem occur that is covered by this warranty, take the product and
FCC Information
the RadioShack sales receipt as proof of purchase date to any RadioShack
store in the U.S. RadioShack will, at its option, unless otherwise provided by
This equipment has been tested and found to comply with the limits for a
law: (a) repair the product without charge for parts and labor; (b) replace the
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
product with the same or a comparable product; or (c) refund the purchase
designed to provide reasonable protection against harmful interference in
price. All replaced parts and products, and products on which a refund is
a residential installation. This equipment generates, uses, and can radiate
made, become the property of RadioShack. New or reconditioned parts and
radio frequency energy and, if not installed and used in accordance with
products may be used in the performance of warranty service. Repaired or
the instructions, may cause harmful interference to radio communications.
replaced parts and products are warranted for the remainder of the original
ON/OFF.
However, there is no guarantee that interference will not occur in a particular
warranty period. You will be charged for repair or replacement of the product
installation. If this equipment does cause harmful interference to radio or
made after the expiration of the warranty period.
television reception, which can be determined by turning the equipment off
6
RADIOSHACK EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDI-
TIONS NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED WAR-
RANTIES THAT MAY BE IMPOSED BY LAW, INCLUDING THE IMPLIED
WARRANTY OF MERCHANTABILITY AND, IF APPLICABLE, THE IMPLIED
WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, SHALL EXPIRE ON
THE EXPIRATION OF THE STATED WARRANTY PERIOD.
EXCEPT AS DESCRIBED ABOVE, RADIOSHACK SHALL HAVE NO LIABILITY
OR RESPONSIBILITY TO THE PURCHASER OF THE PRODUCT OR ANY
OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR
DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE
OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WAR-
RANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING
FROM INCONVENIENCE AND ANY LOSS OF TIME, DATA, PROPERTY,
REVENUE, OR PROFIT AND ANY INDIRECT, SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES, EVEN IF RADIOSHACK HAS BEEN ADVISED
OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow limitations on how long an implied warranty lasts
or the exclusion or limitation of incidental or consequential damages, so the
above limitations or exclusions may not apply to you. This warranty gives you
specific legal rights, and you may also have other rights which vary from state
to state. You may contact RadioShack at:
RadioShack Customer Relations
300 RadioShack Circle, Fort Worth, TX 76102
04/08
www.RadioShack.com
Protect the environment by recyling used electronics. Go to
E-CyclingCentral.com to find an electronic recycling center near you.
©2011. RadioShack Corporation.
All rights reserved. RadioShack and RadioShack.com
Printed
02B11
are trademarks used by RadioShack Corporation.
in China
61-140
7
8
Advertisement
