Radio Shack 61-140 Manual

61-140
Two-Bell Wireless
Door Chime
wireless door chime remote doorbell
Thank you for purchasing your Two-Bell Wireless
Door Chime from RadioShack. You can use it as a
doorbell, remote pager and panic switch.
wireless door chime remote doorbell 1
remote mounting brackets (2) remote doorbell 2
lanyard (strap) user's guide
M 3 screw* (4) M 2.6 brass
screw* (2)
M 3.5 screw* (5) anchor* (5)
* all screws shown at actual size
Please read this user's guide before
installing, setting up and using your new product
www.radioshack.com
61-2117
Install 3 C batteries in your wireless door
chime.
Install 3 AAA batteries in each remote
doorbell.
Use only fresh batteries of the required size
NOTE
and type.
Remove old or weak batteries that might leak
and damage electronic circuits.
Don't mix old and new batteries or battery
chemistries.
Mount your chime on a wall...
Drill a 1/4-inch hole and insert an anchor.
Screw an M3.5 screw into the anchor,
leaving the head extended about 1/8-inch.
Align the chime's rear keyhole slot to the
screw head and slide the chime down.
OR set your chime on a fl at surface using the
supplied stand
drill fl athead screwdriver
C battery (3)* AAA battery (6)*
*Batteries not supplied
carry a doorbell with you as a panic alarm or
to let someone you frequently visit (such as an
elderly parent) know you have arrived coming...
OR mount your doorbell
Mark two holes using your doorbell holder.
Drill a 1/4-inch hole at each mark.
Insert an anchor in each hole.
Align your doorbell holder with the anchors
and screw an M3.5 screw into each anchor.
Slide your doorbell into the holder. To lock
the doorbell in place, insert an M2.6 screw
into the bottom of the doorbell holder.