Table of Contents
Advertisement
BURNER TUBE CLEANING
OR REPLACEMENT (continued)
Reinstall Manifold
You will need: A Phillips screwdriver, two 7/16" wrenches .
A) Align valves with burner tubes . Using two 7/16"
wrenches, install bolts and nuts that secure manifold
to cookbox (1) .
B) With a Phillips screwdriver, install screws and
washers that secure manifold to front cross brace (2) .
If manifold was properly reinstalled, valves will now be
fully seated inside burner tubes .
m CAUTION: The burner tube openings (3)
must be positioned properly over the
valve orifices (4).
m WARNING: You should check for gas
leaks every time you disconnect and
reconnect a gas fitting. (Refer to
"CHECKING FOR GAS LEAKS.")
C) Replace cookbox components (not pictured) .
Reinstall Control Panel
You will need: A Phillips screwdriver .
A) Guide the two wires on back of control panel over
front cross brace and down into cabinet (5) .
B) Align valve stems with holes in control panel . Position
top edge of control panel on tabs of frame assembly .
Push control panel down into position .
C) Fasten control panel with screws .
D) Place burner control knobs onto valve stems .
E) Connect the wires to the ignitor module . Snap wires
back into wire clips on inside left panel . Refer to
"MAINTAINING THE ELECTRONIC CROSSOVER
IGNITION SYSTEM" for proper positioning .
m WARNING: Make sure that all parts
are assembled and hardware is fully
tightened before operating the barbecue.
Your actions, if you fail to follow this
product warning, may cause a fire, an
explosion, or structural failure resulting
in serious personal injury or death as
well as damage to property.
24
WWW.WEBER.COM
ANNUAL MAINTENANCE
1
2
STORAGE AND/OR NONUSE
For barbecues that have been stored or left unused for a while, it is important to follow these guidelines:
•
The gas must be turned off at the LPG cylinder when the Weber gas barbecue is not in use .
•
If storing the Weber gas barbecue indoors, first DISCONNECT the gas supply and store the LPG cylinder
outdoors in a well-ventilated space .
•
Do not store a disconnected LPG cylinder in a building, garage, or any other enclosed area .
•
If you do not disconnect the LPG cylinder from the Weber gas barbecue, be sure to keep both the barbecue
and the LPG cylinder outdoors in a well-ventilated area .
•
The Weber gas barbecue should be checked for gas leaks and any obstructions in the burner tubes before it
is used . (Refer to "CHECKING FOR GAS LEAKS" and "ANNUAL MAINTENANCE . " )
•
Check that the areas under the control panel and the slide-out grease tray are free from debris that might
obstruct the flow of combustion or ventilation air .
•
The spider/insect screens should also be checked for any obstructions . (Refer to "ANNUAL MAINTENANCE . " )
3
4
5
Advertisement
Table of Contents
