Table of Contents
Advertisement
BURNER TUBE CLEANING
OR REPLACEMENT
Confirm that Barbecue Is Off
A) Turn gas supply off at source and disconnect gas
fitting .
B) Check that all burner control knobs are in the
off ( ) position . Check by pushing burner control
knobs in and turning them clockwise until they stop .
If they do not turn, they are already off . If they do turn,
continue turning them clockwise until they stop; then
they are off . If your barbecue has a side burner, make
sure the side burner control knob is turned off .
Remove Control Panel
You will need: A Phillips screwdriver .
A) Open cabinet door . Remove ignitor wires from wire
clips on the inside left panel (1) . Disconnect wires
from ignitor module inside the cabinet (2) .
NOTE: Do not disconnect by pulling on wires; pull from
terminals at ends of wires.
B) Remove cookbox components (3) .
C) Remove burner control knobs (4) .
D) Remove screws from the front of the control panel
with a Phillips screwdriver (5) .
E) Carefully lift control panel up and then pull forward
and away from cookbox (6) .
Remove Manifold
You will need: A Phillips screwdriver, two 7/16" spanners .
A) With the Phillips screwdriver, remove two screws
and two washers attaching manifold to front cross
brace (7) .
B) Using two 7/16" spanners, remove two bolts and two
nuts attaching manifold to cookbox (8) . Pull manifold
forward and away from burner tubes (9) . Manifold will
remain attached to corrugated gas line(s) . Be careful
not to let manifold scratch frame or door or kink the
attached corrugated gas line(s) .
20
WWW.WEBER.COM
ANNUAL MAINTENANCE
1
3
5
9
2
4
6
7
8
Advertisement
Table of Contents
