Table of Contents
Advertisement
METHODS OF BURNER
IGNITION
There are two ways to ignite
burner 1 . The first is by using
the electronic Crossover
ignition system built into your
barbecue . The second is with
a match .
Next are the steps for igniting
your barbecue using the
electronic Crossover ignition
system . On the following page
are steps for igniting your
barbecue with a match .
Some batteries have a plastic
protective wrap around them.
This plastic must be removed
before you attempt to ignite
your barbecue with the
electronic Crossover
system. Do not confuse this
plastic with the battery label.
16
WWW.WEBER.COM
MAIN BURNER IGNITION & USAGE
MAIN BURNER IGNITION
Electronic Crossover Ignition System
The electronic Crossover ignition system ignites burner
1 with a spark from the igniter electrode inside the Gas
Catcher ignition chamber . You generate the energy for
the spark by pushing the igniter button . You will hear the
igniter clicking . Burner(s) 2 (and 3) can be lit after burner
1 is lit .
A) Open the barbecue lid (1) .
Failure to open the lid before igniting
the barbecue's burners, or not waiting
five minutes to allow the gas to clear if
the barbecue does not light, may result
in an explosive flare-up which can cause
serious bodily injury or death.
B) Make sure ALL burner control knobs are turned
off (2) . Check by pushing control knobs in and turning
them clockwise until they stop .
m WARNING: The burner control knobs
must be in the OFF position before
turning on the LPG cylinder valve.
C) Turn the LPG cylinder on by SLOWLY turning the
cylinder valve anticlockwise (3) .
D) Push burner 1 control knob in and turn it
anticlockwise to start/high ( ) position (4) .
IMPORTANT: Always ignite burner 1 first. The other
burner(s) ignite from burner 1.
E) Push and hold in the igniter button (5) . You will hear
the igniter clicking .
F) Check that burner 1 is lit by looking through the
cooking grates . You should see a flame .
m WARNING: While igniting the barbecue
or cooking, never lean over open
barbecue.
m WARNING: If burner 1 fails to ignite
within five seconds, stop, turn the burner
control knob to off and wait five minutes
to allow the gas to clear before you try
again or light with a match.
G) After burner 1 is lit, you can turn on burner 2 (and
burner 3) .
TO EXTINGUISH BURNER
Push each burner control knob in and turn it clockwise to
the off ( ) position . Turn gas supply off at the source .
ignition
™
m DANGER
1
2
3
4
5
Advertisement
Table of Contents
