Table of Contents
Advertisement
General Info.
Getting Started
Operation
Printing a Card
Cleaning
Troubleshooting
Specifications
Appendix A
Appendix B
Appendix C
38
B
- MAGNETIC ENCODER CLEANING
There exists two different processes to clean the Magnetic Stripe Encoder.
The first process consists of a standard cleaning of the printer. This cleans
the most important parts of the printer; including the Print head, Transport
Roller and Magnetic Stripe Encoder (refer to chapter 4 "Cleaning" for more
instructions).
The second process consists of a cleaning of the Magnetic Encoder using
the Menu Button from the LCD Display.
To access the Magnetic Encoder Cleaning Menu proceed as below:
Track #
Field Separator
1
^
2
=
3
=
*
Bit per inch
† Except the '?' character
‡ Including Start, Stop and LCR characters. Also note that these 3 characters are
automatically managed by the magnetic encoder according to the ISO Standard
Norms.
NOTE: Refer to the Card Printer Programmer's Manual for complete programming
information.
P75i
User's Manual
1. Leave power on.
2. Remove cards from the Card Feeder
3. Insert one Pre-Saturated Cleaning Card
(provided) through slot on the side of the Card
Cartridge.
4. Press the Menu button until the LCD screen
shows CLEANING MENU.
5. Press the Select button to select.
6. Press the Menu button again until the LCD
screen shows CLEAN MAG HEAD.
7. Run this operation by pressing the Select
button.
Valid Characters
Track density
Alphanumeric
210 BPI*
(ASCII 20~95†)
Numeric
75 BPI*
(ASCII 48~62)
Numeric
(ASCII 48~62)
210 BPI*
# of characters
79‡
40‡
107‡
Advertisement
Table of Contents
