Standards / Regulations - Wolf SM2 Installation And Operating Instructions Manual

Standards / Directives
Installation /
Commissioning
Warnings
Maintenance / Repair
4

Standards / Regulations

The appliance and control accessories comply with the following
regulations:
EC Directives
- 2006/95/EC
- 2004/108/EC EMC Directive
EN Standards
- EN 60730-1
- EN 55014-2
- EN 60529
- According to DIN EN 50110-1, only qualified electricians may
carry out the installation and commissioning of the heating control
unit and connected accessories.
- Observe all regulations stipulated by your local power supply
utility and all VDE or local regulations.
- DIN VDE 0100 regulations regarding the installation of high
voltage systems up to 1 000 V.
- DIN VDE 0105-100 operation of electrical systems.
- Never remove, bypass or disable safety and monitoring
equipment.
- Only operate the system in perfect technical condition.
Immediately remove / remedy any faults and damage that may
impact on safety.
- Always ensure that cold water is mixed in with hot water, when
the DHW temperature is set above 60 °C (risk of scalding).
- Regularly check the perfect function of all electrical
equipment.
- Only qualified personnel may remove faults or repair damage.
- Only replace faulty components or equipment with original Wolf
spare parts.
- Always maintain specified electrical protection values (see
specification).
Any damage or loss resulting from technical modifications to Wolf
Note
control units is excluded from our warranty.
Low Voltage Directive
3062438_0309