Husqvarna R 214T Operator's Manual page 28

Problem
The starter motor does not turn
the engine over
The engine does not start when
the start motor turns the engine
over
The engine does not run smooth-
ly
The engine apparently has no
power
The transmission does not have
sufficient power
The battery does not charge
There is vibration in the product
28
Cause
The parking brake is not applied. See
page 15 .
The lift lever for the cutting deck is in mow position. See
cutting deck on page 13 .
The main fuse is blown. See
The ignition lock is defective.
The connection between the cable and the battery is bad. See
page 10 .
The battery is too weak. See
The starter motor is defective.
There is no fuel in the fuel tank. See
The spark plug is defective.
The ignition cable is defective.
There is dirt in the carburettor or fuel line.
The spark plug is defective.
The carburettor is incorrectly set.
The air filter is clogged. See
The fuel tank vent is blocked.
There is dirt in the carburetor or fuel line.
The air filter is clogged. See
The spark plug is defective.
There is dirt in the carburetor or fuel line.
The throttle cable is incorrectly adjusted.
The transmission cold air intake or the cooling fins are blocked.
The fan on the transmission is damaged.
There is no oil in the transmission or the oil level is too low. See
of the transmission oil level on page 27 .
The battery is defective. See
The connection at the cable connectors on the battery terminals is bad. See
Battery safety on page 10 .
The blades are loose. See
One or more of the blades are unbalanced. See
25 .
The engine is loose.
To apply and release the parking brake on
To replace the main fuse on page 20 .
To charge the battery on page 21 .
To fill fuel on page 12 .
To remove and install the air filter on page 20 .
To remove and install the air filter on page 20 .
Battery safety on page 10 .
To examine the blades on page 25 .
To examine the blades on page
To lift and lower the
Battery safety on
To do a check
1686 - 002 - 16.12.2021