Husqvarna R 214T Operator's Manual page 17

3. TRANSMISSION, CONTROLS AND DRIVE SYSTEM
Do an inspection of and adjust the front and rear wheel rotation speed (only
AWD).
Replace the transmission filter (only AWD).
Replace the spin on filter for the servo (if applicable).
Do a check of the cooling fan on the hydrostatic transmission.
Do a check of the oil in the transmission and fill if it is necessary. Refer to
a check of the transmission oil level on page 27 .
Examine and adjust the parking brake.
Replace the oil in the transmission. Refer to
oil level on page 27 .
4. CUTTING EQUIPMENT
Clean the outer and inner surfaces of the cutting deck and the cutting deck
covers.
Do a check of and adjust the cutting height and pitch setting.
Examine the blades in the cutting deck, sharp and balance if needed.
5. LAST INSPECTION AND DOCUMENTATION
Do a check of and adjust the engine RPM.
Make sure that the product does not move in neutral position.
Do a check of the forward drive and the rearward drive on different speeds.
Do a check of the blade engagement, seat, lift and forward drive/brake. Refer to
Safety devices on the product on page 8 .
Do an inspection of the collection system (if applicable).
To clean the product
CAUTION:
washer or a steam cleaner. Water can go
into bearings and electrical connections and
1686 - 002 - 16.12.2021
To do a check of the transmission
Do not use a high-pressure
First
servicing
To do
First
servicing
First
servicing
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
Maintenance interval
in hours
50 100 200
O O
O
O
O O
O
O O
O
Maintenance interval
in hours
50 100 200
O O
O O
O
Maintenance interval
in hours
50 100 200
O O
O O
O O
O O
O O
O
O
O
17