Table of Contents
Advertisement
Handling Liquid Damage
Moisture and liquid can damage your cordless phone1
If the handset, repeater, or charger is exposed to moisture or
liquid, but only the exterior plastic housing is affected, wipe off
the liquid, and use as normal1
If moisture or liquid has entered the plastic housing (i1e1 liquid
can be heard in the phone or liquid has entered the handset
battery compartment or vent openings on the base), follow these
steps:
Handset
1.
Remove the battery cover and disconnect
the battery.
2.
Let dry for at least 3 days with the battery
disconnected and the cover off for
ventilation.
3.
After the handset dries, reconnect the battery
pack and replace the cover. Recharge the
battery fully (15-20 hours) before using.
IMPORTANT: You must unplug the telephone line while recharging
the battery pack to avoid charge interruption1
CAUTION! DO NOT use a microwave oven to speed up
the drying process. This will cause permanent damage
Specifications
AC
adapter
Battery
pack
ECT R006 OM.indd 9
Important Information
to the handset, base and the microwave oven.
AAD-041S(M) /
Part number
AAD-600S(M)
Input voltage
240V AC, 50Hz
9V DC@ 350mA / 9V
Output voltage
DC@210mA
Part number
BT-694 or BT-694s
650mAh (BT-694) or
Capacity
500mAh (BT-694s)
Repeater or charger
1.
Disconnect the AC adapter to cut off
the power.
2.
Let dry for at least 3 days before
reconnecting.
Use only the supplied AC adapters.
Be sure to use the proper adapter for
the base and any repeater or charger.
Do not place the power cord where it
creates a trip hazard or where it could
become chafed and create a fire or
electrical hazard.
Do not place the unit in direct sunlight
or subject it to high temperatures.
9
15/6/10 2:13:27 PM
Advertisement
Table of Contents
