Varia RCT715 Device Status LED
LED State
Flashing purple
Flashing blue
Flashing green
Solid green
Flashing yellow
Flashing red
Solid red
Varia RCT715 Camera Status LED
LED State
Solid red
Flashing red
Alternating red and yellow flashes The memory card is low on space.
Flashing yellow
Solid green
Flashing green
Flashing blue
Tail Light Modes and Intensity
You can switch the Varia RCT715 tail light modes by pressing the device button
Mode
Solid (default)
Peloton (group ride)
Night Flash
Day Flash
Standby
Turning Off the Device
Hold the device button for 2 seconds
NOTE: You can also hold both buttons for 4 seconds to lock the device, preventing it from turning on.
Introduction
Status
The device is in active pairing mode.
The device is in smart mode and can be controlled by a paired compatible
Garmin device.
The device is charging.
The device is fully charged.
The device is in lock mode.
The device has approximately 60 or fewer minutes of battery life
remaining.
An error occurred. You may need to restart the device.
Status
The device is recording video.
The device is saving a video or photo.
There is a problem with the memory card.
The memory card is being formatted.
The device is in mass storage mode.
The device is powering on.
The memory card is being accessed.
The device is in Wi‑Fi
Light Intensity
High
Moderate
High
Maximum
Off
(Device Overview, page
®
sharing mode.
(Device Overview, page
Default Flash Behavior
None
None
Slow
Occasional
None
4).
4).
Flash Behavior when
Vehicle Approaches
Light flashes
Light flashes softly
Light flashes quickly
Light flashes quickly
The device does not
detect vehicles
5