Bowl And Tools - Bosch MUMVH48BCN Instruction Manual

Bowl and tools

Observe the application examples in
table M
W Risk of injury from rotating tools
While the appliance is operating, never
place fingers in the mixing bowl. Attach the
cover (12) before operating the appliance!
Do not change tools until the drive has
come to a standstill – when the appliance
is switched off, the drive continues running
briefly and stops in the tool change position.
Do not move the swivel arm until the tool
has come to a standstill. Always secure
unused drives with protective drive covers.
Attention!
Use bowl with this appliance only.
Professional flexi stirring
whisk (13)
for stiring mixtures, e.g. cake
mixture, fruit cake, ... and folding in
ingredients such as raisins and chocolate
chips
Professional beating whisk (14)
for whisking egg whites and cream
(min. 30 % fat content) and for
mixing sponge mixture
Kneading hook (15)
for kneading dough e.g. yeast
dough, bread dough, pizza dough,
pasta dough, pastry and folding in ingre-
dients such as seeds into the dough
Important information
concerning the use of the whisk
Figure D:
The whisk should almost touch the bottom
of the bowl to ensure that the ingredients
are optimally mixed. If not, adjust the height
of the whisk as follows:
■ Remove mains plug.
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the whisk into the drive
until the whisk locks into position.
■ Hold whisk in place and loosen nut
clockwise using open-ended wrench
(size 8).
■ Set the whisk to the optimum height by
rotating the whisk:
– Turn clockwise: Raise
– Turn anti-clockwise: Lower
■ Press the Release button and
move the swivel arm to
position 1.
■ Check the height of the whisk
and, if required, correct.
■ When the height has been set
correctly, press Release button
and move the swivel arm to
position 2.
■ Hold whisk in place and tighten nut
anticlockwise using open-ended wrench
(size 8).
Working with the bowl and the
tools
Figure E:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti-clockwise until it locks
into place.
■ Depending on the processing task,
insert the stirrer, whisk or kneading hook
until it locks into position.
Note:
If using the kneading hook, rotate the dough
deflector until the kneading hook can lock
into position (Fig. E-4b).
■ Put the ingredients to be processed into
the bowl.
■ Press the Release button and
move the swivel arm to
position 1.
■ Attach the cover.
■ Set the rotary switch to the desired
setting.
Adding more ingredients
■ Switch off the appliance with the rotary
switch.
Bowl and tools en
25