NLSoftening System
NoteSet the device to the
determined water hardness.
→ †Set water softening", page
26
With a water hardness of 0 - 6 °dH you
do not need to use softening salt and
you can switch off the water softening.
→ †Switching off water softening",
page 27
Set water softening
Set the device to the water hardness.
Determine the water hardness and the
1.
desired setting value.
→ †Overview of the water
hardness settings", page 25
Press.
2.
Approx. 3 seconds on
3.
to access the basic settings.
aThe display shows Hxx. aThe
display shows
to give.
Just as often on
4.
the desired water hardness has
been set.
The factory setting is H04.
To save the settings, press . for
5.
about 3 seconds
Softening salt
You can soften the water with
softening salt.
Filling softening salt
If the Refill softener salt indicator
lights up, top up the softener salt in
the softener salt reservoir
immediately before the program
starts. The amount of softening salt
required depends on the water
hardness. The higher the
26
Busy-
reflected
press until
to press.
water hardness, the greater the
amount of softening salt required.
PAY ATTENTION!
†Dishwasher detergent can damage the water
damage hardening.
Only fill the water softener
▶
reservoir with dishwasher
softening salt.
†The rinse aid container can be
corrode softening salt.
To ensure that spilled softening
▶
salt is rinsed out of the rinse aid
container, fill the softening salt
into the softening salt reservoir
immediately before the program
starts.
Open the lid of the softening salt
1.
reservoir and remove it.
When using for the first time: fill the
2.
reservoir completely with water.
3. NoteOnly use dishwasher
softening salt.
Do not use salt tablets. Do not
use table salt.
Place the softening salt in the
softening salt reservoir.