Removal And Replacement Procedures; Table 5-1 Hardware Torque Values - Garmin GTN 725 Maintenance Manual

Hide thumbs Also See for GTN 725:

Table of Contents

5 REMOVAL AND REPLACEMENT PROCEDURES

This section addresses removal and replacement procedures for the GTN unit as well as a limited number

of field replaceable components and connector hardware. Due to extensive calibration and other

requirements, field repair is limited to replacing the parts listed in table 7-1.

CAUTION

Removal or replacement of components not addressed in this section by any person other

than a Garmin authorized repair station representative may void the product warranty.

For complete information regarding Garmin aviation warranty policies and procedures,

refer to Garmin Aviation Warranty Policies and Procedures, P/N M02-60069-00.

CAUTION

Removal and replacement of GTN field replaceable components should be conducted at

an ESD safe workstation. Failure to do so may result in damage to the GTN.

NOTE

With regard to the GTN unit only, directional references assume the display head of the

fully assembled GTN 725/750 is facing AWAY from the viewer.

NOTE

With regard to the GTN rack only, directional references assume the viewer is facing the

installed GTN rack.

Refer to table 5-1 when replacing hardware on the GTN 725/750.

Size-Pitch

4-40

190-01007-01

Rev. 5

Torque ± Tolerance (in-lb)

8 ± 1

GTN 725/750 Maintenance Manual

Page 5-1

Table of Contents

Gtn 750