Table of Contents
Advertisement
I I n n s s t t a a l l l l a a t t i i o o n n
Figure 17. Four-inch (101.6 mm) RuptureGuard mounting, to 3-in. (76.2 mm) chiller flange
Chiller
Gasket
N N o o t t e e s s : :
•
Adaptations may occur in the field-fabricated vent piping system installation due to variations on specific job
sites. It may be necessary to fabricate an elbow, spool adapter, off-set, or other component to accommodate
these variations. Follow all instructions in this manual and contact your local Trane representative with any
questions.
•
If a customer-supplied adapter is needed for the configuration, the spool piece may not be required.
•
Four-inch (101.6 mm) RuptureGuard ™ valve assembly (without spool piece) is used ONLY with 250E Heat
Recovery CenTraVac ™ chillers; some models may require additional parts (i.e., thread-reducing flange, stud,
and nut).
18
Acceptable
Locally
Gasket
Provided Piping
Options
(showing orientation)
RuptureGuard
Spool
Piece
Flow Direction
Spool Piece
Gasket
Locally
Provided Piping
to Vent and
Drip Leg
Note: All piping per
ASHRAE Standard 15.
CTV-SVX06J-EN
Advertisement
Table of Contents
