Dynamic Range Compression - Panasonic SA-XR30 Operating Instructions Manual

BAND
A/D attenuator
Turn the A/D attenuator on if "OVERFLOW"
lights frequently when using 2-channel
analog input.
The factory setting is OFF.

Dynamic range compression

Change this setting to listen to software
recorded with Dolby Digital at low volume
(such as late at night) maintaining audio
clarity. It reduces the peak level in loud
scenes without affecting the sound field.
OFF:
The software is played with the original
dynamic range (factory setting).
STANDARD:
The level recommended by the producer of
the software for household viewing.
MAX:
The maximum allowable
(recommended for night viewing).
Dual program
When the input signal is Dolby Digital and
"DUAL" appears in the display, the audio to
be output is set.
MAIN: Main audio output
SAP: Sub channel audio output
MAIN+SAP: Main and sub channel audio
output
The factory setting is MAIN.
DTS FIX mode
In rare cases, the unit may have trouble
recognizing the digital signals on discs.
With DTS, the signals may not be recognized
at all. Engage the DTS FIX mode if this
occurs.
When DTS FIX mode is on, the unit cannot
process other signals. This may cause noise
to be output. Turn the setting off in this case.
• When you turn the unit to standby, the DTS
FIX mode is canceled.
- HELP
-
SPEAKERS
RESET
-
HELP
SPEAKERS - RESET
POWER 8
1. Enter the setup
mode.
- HELP
-
SPEAKERS RESET
Press and hold at the
same time
SETUP
1. Enter the setup
mode.
- HELP
-
SPEAKERS RESET
Press and hold at the
same time
SETUP
compression
1. Enter the setup
mode.
- HELP
-
SPEAKERS RESET
Press and hold at the
same time
SETUP
While the input source is selected
TUNE 1
BAND
Press and hold at
the same time for
2 seconds.
INPUT SELECTOR
TUNE 1
INPUT SELECTOR VOLUME
DOWN
2. Select. 3. Select.
- HELP
-
SPEAKERS RESET
A/ D ATT
2. Select. 3. Select.
- HELP
-
SPEAKERS RESET
DR COMP
OFF, STANDARD, MAX
2. Select. 3. Select.
- HELP
-
SPEAKERS
RESET
DUAL PRG
MAIN, SAP, MAIN
DTS FIX
• To cancel, perform the same operation again.
"AUTO" is displayed.
UP
PHONES
4. Exit the setup
mode.
INPUT SELECTOR
SPEAKERS
Press and hold at the
same time
OFF
COMPLETE
OFF ON
4. Exit the setup
mode.
INPUT SELECTOR
SPEAKERS
Press and hold at the
same time
OFF
COMPLETE
4. Exit the setup
mode.
INPUT SELECTOR
SPEAKERS
Press and hold at the
same time
MAIN
COMPLETE
+
SAP
- HELP
-
RESET
- HELP
-
RESET
- HELP
-
RESET
17